Thesprucecrafts.com

Thesprucecrafts.com just updated 0 Coupon code and 19 Deals. In candle making "cure" refers to the chemical process that takes place as the wax and fragrance oil bind and incorporates into each other. Think of it like a spaghetti sauce, chili, or a salsa—the flavors (or scents in this case) perform better after they've had some time to meld together with the wax—to "set."

Filter Type:

Remove All Sanding Dust Before Finishing Wood

2 days ago Vacuum or Blow Off Dust. Start by blowing off the bulk of the sawdust and sanding residue t using an air compressor fitted with a blower nozzle. Even better is vacuuming every surface and crevice of your project with a shop vacuum fitted with a good quality filter designed to trap the microscopic dust.

98% Success 82 Used

  Deal Now

How to Adjust Your Gauge in Knitting

2 days ago If you don't take the time to check your gauge and it ends up being way off from what the pattern suggested, you'll end up with a project that's much bigger—or smaller—than you intended. But it's not always easy to figure out what to do to alter your gauge. If you've knit a swatch with the needles specified and it's not right, what can you do?

98% Success 67 Used

  Deal Now

The Construction Definition of On-Center (OC) Spacing

2 days ago The term "on-center," often abbreviated "OC" (or "o.c.)," is commonly used in construction drawings, architectural plans, and woodworking designs. It indicates that the given dimension refers to the distance between the center of one framing member to the center of the next member.

98% Success 59 Used

  Deal Now

How to Sell the Coins That I've Inherited

2 days ago Follow this advice, and you will avoid getting ripped off when you sell the coin collection that you've inherited. 01 of 07. A Few Quick Do's and Don'ts . Corbis via Getty Images / Getty Images. If you are not a coin collector, there is a lot to learn. The more information you possess will give you the advantage when it comes time to sell.

98% Success 72 Used

  Deal Now

Tips for Applying Polyurethane for a Perfect Finish

2 days ago Apply the finish in a clean, well-ventilated area. Polyurethane takes hours, not minutes, to dry; that's a lot of time for dust to settle or bugs to land on the surface, marring the final product. Both water-based and oil-based products give off strong fumes as they dry (although oil-based is decidedly worse), so proper ventilation is a must.

98% Success 96 Used

  Deal Now

How to Start and End an Embroidery Thread Without Knots

2 days ago Away Knot: An away knot is worked 3 to 5 inches away (hence its name) from the area where the embroidery begins.The knot is clipped after working the embroidery, and then you thread your needle with the tail and weave it through the stitches on the backside of the fabric in the same manner as you weave the tail when ending a thread.

98% Success 75 Used

  Deal Now

Easy Tips for Cleaning and Restoring Vinyl Doll Skin

2 days ago Anyone familiar with Dawn dishwashing products knows that the liquid detergent was used to clean off wildlife that had been trapped in oil slicks. It was gentle enough to salvage the feathers of ducks and other waterfowl. Dawn or other brands that are equally gentle can be applied to vinyl or plastic doll skin. Again, wipe gently.

98% Success 72 Used

  Deal Now

Steps for Binding off in Knitting

2 days ago Once you've cast on, knitted and purled your pattern, and basically finished your project, there's just one more step that has to be completed—getting your project off the needles. This is accomplished by what's known as binding off or casting off. It is a simple and quick method for making a finished edge.

98% Success 73 Used

  Deal Now

Basic Techniques for Cutting With a Band Saw

2 days ago After completing the cut, turn off the saw, adjust the fence, and repeat. TIP: To keep the board held evenly against the fence, install a featherboard onto the table to the right of the board in front of the blade. As you ease the board through the blade, the featherboard will hold it tightly against the fence.

98% Success 74 Used

  Deal Now

Weave-In Warp Threads on Loom Beadwork

2 days ago Turn each warp bar toward the middle of the loom until the warp threads on both ends are completely unwound. If you used the winding method to warp your loom, use the tips of beading scissors to gently pry the looped thread off of the warp anchor on the front end of the loom (as shown in the photo on the left).

98% Success 85 Used

  Deal Now

How to Knit a Stretchy Bind Off - thesprucecrafts.com

2 days ago A knitter can never have too many different cast on and bind off techniques in their arsenal. This stretchy bind off is very simple and is great to use at the edges of shawls that need to be stretched out in blocking, and on cuffs.

98% Success 93 Used

  Deal Now

How to Weave in Ends in a Knitting Project

2 days ago Weaving in ends in knitting is always a necessary step at the end of a knitting project. Even the smallest project has at least two ends: one at the cast on edge and one at the bind off edge. Larger and more complex projects can have many, many ends to weave in. Weaving in ends is essential to give your project a finished look and to keep those ends from getting loose and causing your knitting

98% Success 68 Used

  Deal Now

Identifying Antique and Modern Fiesta Dinnerware

2 days ago Fiesta, made by Homer Laughlin China Company, was the company’s most successful line of dinnerware.It was conceived by Frederick Hurten Rhead, who was hired by the company as the head designer in the late 1920s.

98% Success 70 Used

  Deal Now

10 Practical Tips for Fabric Painting

2 days ago Purists say the best fabric for painting on is 100% cotton with a tight weave (an off-white or cream fabric will dull the paint slightly). But good results can be obtained with rayons and silks too. The best is to try a sample square to check the results.

98% Success 75 Used

  Deal Now

Is Rolling Up a Canvas Painting Safe?

2 days ago How to Get a Canvas Painting off Stretchers . To remove a painting from its stretchers, you need to take your time and pay attention through the entire process. This is a risky task and you do not want to risk damaging all of your hard work. Remove the staples or nails that hold the canvas onto the stretchers.

98% Success 93 Used

  Deal Now

The Complete Rules of Backgammon

2 days ago For example, if one or more of your checkers are on the bar, you cannot bear off any checkers, even if all of your other checkers are on your home board. You may bear off a checker by rolling the number that corresponds to the point on which that checker resides. For example, if you roll a four, you may remove a checker from the fourth point.

98% Success 72 Used

  Deal Now

How to Use Fabric Markers

2 days ago If you find yourself hesitating, lift the marker off the fabric while you think about what you're doing. 04 of 07. Lettering . Lettering is easier with a fabric marker rather than a brush. Practice makes for neater letters, and a light pencil line helps get the letters straight. Don't obsess over it though, as the irregularity is part of

98% Success 99 Used

  Deal Now

How to Make a Lye Solution for Cold Process Soap

2 days ago If this happens, stop and clean them off immediately. Continue to 4 of 7 below. 04 of 07. Add the Lye to the Water . The Spruce / David Fisher . If your recipe calls for adding sugar or salt to the lye water solution, add it to the water before you add the lye. Stir the water well to make sure the sugar or salt is completely dissolved and then

98% Success 94 Used

  Deal Now